WEEK 7

In week 7 ,as we plans before, we discuss and agree to do the process drilling at the uv board. To do this process,we go at 1st floor to use the equipment drill that already give to used. To drill the hole at uv board, its have different drill bit which have small,normal and large. But in my fyp uv board, we just use a small drill bit. The process we doing maybe not take a long time to make it.

The equipment that we used to doing the process are drill machine,and drill bit and spreader.

There is a box equipment that we used to do this process which are "super mini drill 1PK-500".

Inside the box, the component we used are drill machine (which used battery and can be rechargeable), drill   bit and charger.

After that, we drill the hole at uv board which accordance with the polystyrene. Finally, the process drill are succesfully done.

WEEK 6

In week 6 Our holiday is finished. Time to focus for our project , my partner and i also plan to do etching. So we go to PCB Laboratory Workshop to do it at 1st floor.

1) We put the print circuit trasparent at the UV Box. After that, we put the UV board at the top print circuit and do the process 60s.

2) After that, we put the develop and pour and mix with the water then shake it. This process want to make the circuit appear at UV board.

3) Thus, after done shake, we transfer the PCB into etching tank and do the operation for 4-5 minutes.

4) Lastly,after the process and operation already done, we use sand paper to clean the circuit board. Finally, the circuit appear.

-My friend which help me doing the develop etching PCB togethers. Thanks you my friends. (^_^)

Holiday nd Mid Term Break :)

This week its holiday, for us because we starts holiday from 11-20 October 2013 to celebrate "Hari Raya Aidil Adha" with the family, friends and others. Also, Mid Term break. We as a muslim very proud and happy. Since its holiday, my partner and i plan to do our blog and report for fyp.

WEEK 5

In this week, as we plan before with my partners, we want to construct the circuits on the breadboard. However, to construct the circuits we look and follow the schematics diagrams that we take from magazine.

-There is a schematics diagram that we want to construct on the breadboard.We also edit from buzzer we choose to use motor for our project.

We check and collect all the component is already have, so we can prepare to start construct at the breadbboard.

Now, finally there is a result that my partners and i already finish construct the circuits on the breadboard and testing it if the circuits is functioning or not.

WEEK 4

At week 4,  my partner and i do the some research to make sure that all the component is already have. So we can plans to construct the circuits on the breadboard next week.